Bosch Washer Stuck on Sensing? Here's How to Fix It

Is your Bosch washer staying on sensing and not starting the wash? I know this can be annoying when the machine sounds ready but nothing happens.

Don't worry. There are a few simple reasons for this problem, and most can be checked without opening the washer.

Work through the five checks below and you should find what is holding the cycle.

How to Fix a Bosch Washer Stuck on Sensing

To get a Bosch washer past sensing, check the door, water flow, clothes, and drain hose. Reset the washer before having its controls tested.

Disconnect the power before touching a hose. Do not remove panels if your washer is still under warranty.

Make Sure the Door Is Shut

Move socks and other clothing away from the door seal. Wipe detergent from the latch, then close the door gently.

If the lock does not click, the washer cannot begin. A faulty door lock are best replaced by a technician.

Check How Fast Water Enters

Open both faucets fully and straighten the inlet hoses. Slow water can make the sensing part take much longer than normal.

Clean the small hose screens if they are covered with dirt. If no water enters, read about a Bosch washer that is not filling.

Reduce or Balance the Load

Take out a few clothes if the drum is tightly packed. Spread heavy items evenly so the washer can judge the load.

One wet blanket on one side is a common reason for this issue. These step is simple but worth trying.

Check the Drain Hose

Make sure the drain hose is not pushed too far into the standpipe and is not sealed airtight. Water leaving as fast as it enters can stop the washer from moving on.

Also straighten any sharp bend. A correctly placed hose means the final step is resetting the washer.

Restart It Once, Then Arrange a Repair

Turn off the washer and unplug it for five minutes. Reconnect it, then use our steps to reset your Bosch washer before trying a short cycle.

If it still stays on sensing, a water-level part or control may needs testing. There is few useful checks you can make without the proper meter, so call a technician.

Conclusion

Try these five solutions to move your Bosch washer past sensing:

• Make sure the door is shut
• Check how fast water enters
• Reduce or balance the load
• Check the drain hose
• Restart it once, then arrange a repair if needed

The door and water supply are the two easiest places to start.