Whirlpool Washer Making a Loud Noise During Spin? Try these FIXES!

Have you noticed that your Whirlpool washer is making a loud noise during spin?

I know it is easy to worry when your washer starts banging, grinding, or rumbling. I would start by asking you to stop the cycle and check the load, drum, and washer feet, as an uneven load or a loose object can cause a noise that starts suddenly.

How to Quiet a Noisy Whirlpool Washer During Spin

A Whirlpool washer making loud noise during spin may have a trapped item, uneven load, loose feet, blocked pump, or worn moving part.

As you work, notice whether the Whirlpool washer is loud when spinning only. A loud banging noise points toward movement, while a grinding noise during spin or rumbling noise when spinning may need service.

Level the Washer Feet

Besides this, press gently on opposite top corners of the Whirlpool washer. If it rocks, adjust the feet until each one sits firmly on a hard floor, then tighten the locking nuts if fitted.

Next, if movement is stronger than the sound, follow the checks for a Whirlpool washer that is shaking and moving.

A small leveling foot problem on the Whirlpool often cause a much bigger symptom while you look for the cause.

Remove Loose Items

Further, pause the Whirlpool washer, unplug it, and check the drum, pockets, and reachable seal folds for coins, clips, or other small objects.

Remember, turn the empty drum slowly by hand. Stop if it scrapes or jams, and do not reach below an agitator or open the cabinet.

The loose item on your Whirlpool sometimes need only a simple correction before you decide on service.

Balance the Wash Load

Remember, a towel, blanket, or tangled sheet can gather on one side of the Whirlpool drum and cause a loud banging noise. Spread heavy pieces around and remove a few items if the tub is packed.

Besides this, try a short spin after rearranging the clothes. Stop again if the cabinet begins hitting the wall or the banging returns.

This wash load problem sometimes come and go on a Whirlpool as you compare each result.

Have the Bearings and Suspension Checked

For this check, a rumbling noise when spinning, a loose drum, or metal scraping can point to a bearing, suspension, or drive problem in the Whirlpool washer.

As you work, these repairs involve heavy moving parts. Stop using the machine if it leaks, scrapes, or shakes violently, and ask a technician to inspect it.

This part around the moving part often get forgotten on a Whirlpool washer while you work through the list.

Listen Near the Drain Pump

Next, a grinding noise during spin may actually begin when the Whirlpool washer pumps water out. If the manual shows a user accessible filter, clean it as directed and prepare for water to spill.

For safety, unplug the machine before opening any filter. Do not keep running a noisy pump, because a trapped object can damage it.

Conclusion

Work through the Whirlpool checks in the order that matches what you see, aiming for a quieter spin.

• Level the Washer Feet
• Remove Loose Items
• Balance the Wash Load
• Have the Bearings and Suspension Checked
• Listen Near the Drain Pump