Easy Ways to Fix a Fisher & Paykel Washer that is Not Dispensing Detergent

Is your Fisher and Paykel washer still not dispensing detergent?

I think the simple checks are the right place to start. I would check the detergent amount, drawer channels, and water flow, because dried soap or weak water flow can keep detergent in the drawer.

How to Clean a Fisher and Paykel Washer Soap Drawer

This is what I would check. To fix a Fisher and Paykel washer not dispensing detergent, use the right soap, clean and refit the drawer, check water flow, and level the machine.

So, the same checks help when the Fisher and Paykel washer is not dispensing soap, has a drawer full of water, has a drawer stuck, or is leaving detergent in the drawer.

Put the Drawer Parts Back Firmly

In many cases, push every clean insert fully into its matching Fisher and Paykel drawer compartment. A loose siphon cap can leave the drawer full of water or stop softener from leaving.

At this point, compare the pieces with the diagram in the manual if the drawer does not slide freely after cleaning.

One of these drawer insert check can reveal what changed before you decide on service.

Ask a Technician to Check the Water Valve

Also, a badly tilted Fisher and Paykel washer can leave water sitting at one side of the drawer. Adjust the feet until the cabinet is level and steady.

However, if water never reaches a clean drawer, an inlet valve, passage, or control may be faulty. Ask a technician to test it, and contact Fisher and Paykel first if the machine is under warranty.

Further, if odor remains after the drawer is clean, read how to clean a Fisher and Paykel washer that smells bad.

The washer level on your Fisher and Paykel often show a useful clue as you compare each result.

Clean the Drawer and Its Housing

Before going further, unplug the Fisher and Paykel washer. Never force a drawer that is stuck; use the release shown in the manual for your exact model.

In many cases, follow these steps to remove the buildup:

1. Pull the drawer out until it stops.
2. Press the release shown in the manual and lift the drawer free.
3. Remove loose inserts and soak them in warm water.
4. Scrub each channel with a soft brush, then rinse it.
5. Wipe the empty housing and dry every part before refitting it.

Also, clear only loose residue from the small water holes. Do not push a sharp object into them.

A few minute spent on the Fisher and Paykel detergent drawer can be useful while you work through the list.

Reduce Thick Detergent Buildup

As you work, put detergent in the Fisher and Paykel compartment marked for the main wash, not the bleach or softener section. Use the type required by the manual and measure it for the load.

Before moving on, too much detergent can form a thick paste. Liquid filled above a marked line may also drain too early or remain after the wash.

On a Fisher and Paykel washer, this detergent choice are easy to overlook during a careful check.

Clean the Water Inlet Screens

At this point, open the supply taps and straighten the inlet hoses behind the Fisher and Paykel washer. Weak water flow may leave detergent in the drawer instead of rinsing it into the tub.

Before going further, turn off the water and unplug the machine before removing a hose. If the washer also fills slowly, see why the Fisher and Paykel washer is not filling with water.

Conclusion

Try the safe Fisher and Paykel checks first for a drawer that empties properly, then leave internal repairs to a technician.

• Put the Drawer Parts Back Firmly
• Ask a Technician to Check the Water Valve
• Clean the Drawer and Its Housing
• Reduce Thick Detergent Buildup
• Clean the Water Inlet Screens